I spent a long time looking at recipes on the interweb. The peanut butter topping was quite common, but most slices had either a brownie or shortbread base and I wanted to try something different. In the end I combined various recipes, mostly from Australia with some of my own.
The resulting slice had a chocolate and peanut biscuit base for which I used unsalted roasted peanuts. This was baked before being topped with a layer of peanut butter mixed with sugar and condensed milk and then baked, with thick crazy milk chocolate on top. As the peanut butter layer also needs to be baked to set it, I found it was easy to over bake the biscuit making its slightly dry and crumbly, so if you try this recipe, be aware of that. Not that it didn't taste nice! With all these lovely ingredients, how could it fail to tantalise the taste buds!
I was pleased with the outcome and will definitely make again, but I may need to go to the gym a few times before eating another slice!
Ingredients
For the biscuit base
200g baking
spread
100g caster
sugar
200g
self-raising flour
2
tablespoons cocoa powder
80g unsalted
roasted peanuts roughly chopped
For the peanut butter layer
397g can Sweetened Condensed Milk
280g crunchy peanut butter
55g soft brown sugar
50g butter
1 egg, lightly whisked
For the topping
200g milk
chocolate
15g butter
Method
To make the
biscuit base
1.
Preheat the oven to 180 C / Gas 4. Grease and line a 20cm square deep
baking tin
2.
Cream together margarine and sugar until light and fluffy; stir in flour
and cocoa powder
3.
Mix in the chopped peanuts so that they are well dispersed
4.
Bake in the pre-heated oven until firm around the edges for about 15
minutes
5.
Allow to cool in the tin for around 10 minutes
To make the peanut
butter layer
1.
Reduce the oven to 160 C/ Gas 3
2.
In a saucepan, combine the condensed milk,
peanut butter, brown sugar and butter
3.
Stir over medium–low heat until melted and
smooth. Set aside to cool for 5 minutes.
4.
Whisk in egg and mix well. Pour over base.
5.
Bake for 15-20 minutes or until just set and
golden. Allow to cool completely.
Add the topping
1.
Roughly break up the chocolate and add the butter
2.
Melt in the microwave in short bursts or in bowl over a saucepan of
barely simmering water
3.
Pour over the base layer and spread evenly. Give the tin a little shake
to get a nice smooth finish
4.
Allow the chocolate to set in the fridge – this should take a few hours
Remove from the
fridge and cut into the amount of pieces you would like. You can get 16 normal
sized pieces or fewer of the size you’d actually like to eat!